The most common ceiling fan parts are switches, motors, mounting brackets,capacitors and pulls, just to name a few.

Apart from fan blades, the fan part that usually needs to be replaced is the ceiling fan switch. This part takes a lot of yanking and handling so it is normally subject to frequent damage or breakage. In addition the light switch may stop working over time, and you may be faced with the task of replacing it.

Follow these easy-to-follow steps in replacing your ceiling fan switch:

Tools needed: screw driver, tape, hand pliers

1. Terminate the power. Make sure that you turn the main power off before you start replacing the light switch. De-activate the device that cuts off the circuit. For a better solution, remove the fuse powering the room.

2. Dismantle the bulbs. Find the pull chain and mark it with a piece of tape. This will help avoid the confusion between the pull chain and the fan control switch when the light fixture is removed. manage extrinsic the shades and radiant bulbs by loosening the screws that hold office institute at the implant of each covering.

3. Take out the ballast cover. The ballast cover has light bulbs fixed to it. Take extra care when unscrewing and lowering it. the wrap should not be pull powerfully since it is connected to the ceiling fan

4. Get rid of the light fixture. Detach the seed from the incandescent fixture by molding prosperity of the multifaceted wire harness connecting whole-hog the wires of the ceiling peanut to the wires of the beaming fixture. Press down the release lever so that the wire harness will separate, and place it on a table. avoid the fan switch you marked with tape, and locate the light switch inside the fixture.

5. Replace the old switch. Take the ballast cover cap off and remove the switch which needs changing. Be careful to match the existing wires with the new wires from the fan light switch.

Unscrew the wire nuts connecting every pair of wire from the old switch to detach them. Then, connect the wires of your new switch to the light fixture, and be sure to math one pair at a time. In a clockwise direction, twist the exposed ends of the wires then place the wire nut. To firmly place it, rotate it in clockwise direction. You can do the same with any sets of wires that are the same color.

6. Rearrange. All of your function is done. Put the light switch in the ballast cover then put the threaded end through the hole. The cap that holds the light chain insert the pull chain in that cap. From the light fixture to the fan, reconnect the wires.

Put new screwing on the ballast cover, then reinsert the bulbs.

As a last step, turn the fuse back on to test the switch.

If you are in need of any spare parts to use in your ceiling fan, you can get quality parts through the Internet. As with all other electrical equipment and appliances, you should exercise care when installing new parts, and if you are really unsure of what you are doing have a professional do the work for you.

To find more information on this topic you can find it at Ceiling Fan Switch - which helps people find the best information for The Best Ceiling Fan Switch and ceiling fans parts